ADG Perspective

May-June 2016

Issue link: https://digital.copcomm.com/i/679317

Contents of this Issue

Navigation

Page 52 of 75

P E R S P E C T I V E | M AY / J U N E 2 0 1 6 51 Top, right: Mr. Corenblith's photograph of the engine room set looking aft. "Converging parallel lines are always a plus in a 3D format," he said. Right: A production photograph of the engine room showing the hull breach and the flooding of the lower deck. From this point on the lower deck was flooded to a depth of eight feet to accommodate both stunts and physical effects. its arc. Set Designer Rob Woodruff took the lead creating the wedding-cake-tiered structure of the room, while attending to constant revisions as structural engineering and calculations of dynamic loads were refined. Set decorator Susan Benjamin dispatched a buyer to Brownsville, TX, to a facility that was salvaging merchant vessels of a similar vintage to our tanker. A trio of 48-foot-long trucks returned, loaded with period-correct nautical and marine dressing that was employed throughout the various compartments and quarters. "The initial challenge was creating a gimbal that could accommodate a 45-foot-tall set weighing half a million pounds, then fi lling that set with a quarter million pounds of water, and containing the dynamic load of this combination rotating through its 'wave-induced' motion." Because the steam turbine engines were conceived to replace and displace the volume and weight of the water that would flood their compartment, it was crucial that they had sufficient massing and detail to seem authentic. Set Designer Masako Masuda, working with Rob Woodruff, began with the proposed coffer dam volumes, and then started shaping the engine forms to match. Using photography and field measurements from the 1945 liberty ship SS Lane Victory in San Pedro, as well as the USS Salem which was docked conveniently near our shipyard stage at Fore River Shipyards in Quincy, MA, we were able to create high fidelity replicas that were not only mechanically plausible, but visually pleasing. At the heart of the engine room is the throttle control station, the console where the Chief Engineer controls the propulsion of the remaining half of the ship. The intention was to design something that gave the audience a glimpse into the mind of this character. It needed to be very dense, and only semi-linear in its layout, which can be more difficult than it sounds. After establishing some rough parameters of width, and height, for shooting angles, we harvested the best of the Brownsville-salvaged gauges dials and

Articles in this issue

view archives of ADG Perspective - May-June 2016